GA1 - Digital Printing Question Preview (ID: 41228)
After Completing This Chapter The Student Should Know The Different Digital Printing Technologies.
TEACHERS: click here for quick copy question ID numbers.
Which statement is NOT a step in the imaging process of a toner-based digital press?
a) An image is transferred (or offset) from a metal plate to a rubber blanket
b) A photoreceptive surface is given a negative electrical charge
c) A sheet of paper is positively charged
d) Heat fuses the powder image to the paper
Which is NOT a subsystem of the imaging process within a digital press?
a) Dampening Subsystem
b) Charging Subsystem
c) Exposure Subsystem
d) Development Subsystem
What printing process uses an electrical charge to attract toner particles?
a) Ink jet
b) Electrophotography
c) Thermal ink transfer
d) Dye sublimation
What is the printed image that extends beyond one or more of the finished page margins and is later trimmed so that the image goes off the edge of the sheet.
a) bleed
b) imposition
c) calibration
d) collation
A monochrome digital printer prints in how many colors?
a) 1
b) 2
c) 3
d) 4
Which statement best describes a raster image processor (RIP)?
a) System that translates a page-description language into printing commands
b) A system for performing word processing functions
c) Scanning device used to preset ink fountain keys in preparation for offset printing
d) A device for measuring the reflective properties of surfaces
Which is NOT one of the three stages of raster image processing performed at the RIP?
a) Interpretation
b) Enlarging
c) Rendering
d) Screening
Which choice is NOT a typical capability of a digital press’ finishing system?
a) Collating
b) Stacking
c) Die cutting
d) Stapling
Which post-process finishing capability is a readily available option for many digital presses?
a) Case binding
b) Hole punching
c) Engraving
d) Fabric embroidery
Which statement does NOT describe an attribute of in-line finishing?
a) The press and bindery are in one integrated machine.
b) The printing and bindery equipment are physically separate
c) Enable a quick turnaround of multiple types of jobs
d) Completes a job from start to finish
What type of digital printing is a type of themography that uses heat and pressure to change dye particles into a gas vapor that permeates the substrate?
a) Electrophotography
b) Inkjet
c) Magnetography
d) Dye Sublimation
On a digital press, the place where the finished printed pieces come out of is called the?
a) drum
b) Fuser or Drying Unit
c) Paper Feed or Feeding Unit
d) Stacker or Output Unit
On a digital press, what unit loads the paper
a) Paper Feed or Feeding Unit
b) Printheads or Toner Unit
c) Stacker or Output Unit
d) Fuser or Drying Unit
On a toner based digital press, the part that receives the image is called the?
a) Fuser or Drying Unit
b) Printheads or Toner Unit
c) photoconductor drum
d) Stacker or Output Unit
On a digital press, the unit that adheres the ink or toner to the substrate.
a) Fuser or Drying Unit
b) Printheads or Toner Unit
c) photoconductor drum
d) Stacker or Output Unit
Play Games with the Questions above at ReviewGameZone.com
To play games using the questions from above, visit ReviewGameZone.com and enter game ID number: 41228 in the upper right hand corner or click here.
To play games using the questions from above, visit ReviewGameZone.com and enter game ID number: 41228 in the upper right hand corner or click here.
TEACHERS / EDUCATORS
Log In | Sign Up / Register
Log In | Sign Up / Register