Review Game Zone
Flash Cards
(current)
Games
Teachers
Search
Suspension
Test Description: Steering
Instructions: Answer all questions to get your test result.
1) Technician A says a jounce bumper should be replaced if the rubber is broken or missing. Technician B says the rubber on most jounce bumpers is broken and does not require replacement. Who is right?
A
neither
B
Both
C
A
D
B
2) On a rear-wheel-drive vehicle, dog-tracking may be the result of
A
broken leaf spring center pins/bolts.
B
worn universal joints.
C
worn or leaking shock absorbers.
D
worn brake shoes.
3) 3. When inspecting the lower ball joints on an SLA (short-long arm) suspension, the floor jack should be placed under the:
A
frame.
B
lower control arm.
C
tie-rod
D
pinch weld.
4) 4. While inspecting a strut cartridge, Technician A states that a fluid leak at the seal means the strut cartridge needs to be replaced. Technician B states that if the strut cartridge can be compressed easily, it should be replaced. Who is right?
A
Neither
B
B
C
Both
D
A
5) 5. When bleeding air from the power steering system, most manufacturers recommend doing this procedure with the:
A
transmission in reverse.
B
engine off.
C
engine running at 2,000 rpm.
D
engine running.
6) When inspecting a front strut assembly, one notices a visible drip of fluid around the seal. What should be one's next step
A
Refill the strut with strut oil, and return the vehicle to the owner.
B
Inform the owner that the strut is defective and needs to be replaced.
C
Wipe it clean, and keep an eye on the vehicle the next time the owner brings it in for service.
D
It is normal for a strut to leak fluid.
7) While discussing power steering systems, Technician A says that it is not necessary to flush the power steering system on vehicles with electric assist power steering. Technician B says air in the power steering fluid may cause the power steering
A
Both
B
B
C
A
D
Neither
8) While inspecting tie-rod ends on a rack-and-pinion steering system, Technician A states that a tie-rod end should be replaced if it has any visible movement. Technician B states that all tie-rod ends need to be greased at every service. Who is rig
A
A
B
B
C
Both
D
Neither
9) When turning the front wheels in either direction, the power steering serpentine belt squeals loudly. Which of these should be done to correct the problem?
A
Spray the belt with belt dressing.
B
Inspect the belt for wear and replace as needed, and properly tension the belt.
C
Replace the power steering pump.
D
Tighten the belt so there is no deflection.
10) A customer complains of a whining noise while turning the steering wheel either left or right. The most likely cause is:
A
worn ball joints
B
a worn alternator belt.
C
low fluid in the power steering pump.
D
worn tires.
11) While inspecting the front strut bearing and mount, Technician A states that the bearing should rotate without any roughness. Technician B states that the strut cartridge should be replaced every time the bearing is replaced. Who is right?
A
Neither
B
A
C
B
D
Both
12) When inspecting tie-rod ends, Technician A says a small amount of play is acceptable as long as the tie-rod has a grease fitting to fill the joint with grease for taking up the slack. Technician B says that if the joint dust boot is damaged, the
A
Both
B
B
C
A
D
Neither
*select an answer for all questions
Check Results & Get Answers
Play Games with the Questions Above
Teachers: Create FREE classroom games with your questions
Click for more info!
©2007-2024
ReviewGameZone.com
|
About
|
Privacy
|
Contact
|
Terms
|
Site Map
WAIT! Find what you needed?
×
Still Looking for the Answers?
Have Another Question?
Play a Review Game with These Questions?
Want to Make Your Own Test Like This One?