Advanced Manufacturing Basic Hand Tools 2 Question Preview (ID: 24949)


Basic Hand Tools Set 2. TEACHERS: click here for quick copy question ID numbers.

Which hammer is used to seat a workpiece in a vise?
a) Dead blow
b) Sledge
c) Ball-peen
d) Soft-faced

Which hammer is used to tack brass?
a) Soft-faced
b) Sledge
c) Dead Blow
d) Ball-peen

Which of the following is not a type of plier?
a) Ball-peen
b) Slip joint
c) Groove joint
d) Needle nose

Which hammer is used to shape sheet metal?
a) Ball-peen
b) Sledge
c) Soft-faced
d) Dead blow

Identify the two most common types of utility knoves.
a) Fixed blade and snap-off blade
b) Straight blade and craft blade
c) Fixed blade and straight blade
d) Craft blade and snap-off blade

What reduces the likelihood that the wrong hex key would be used on any given fastener?
a) Only one size of one unit of measurement will fit the fastener
b) All hex keys are the same size
c) Hex keys expand to fit any size fastener
d) Hex keys slip out before rounding over fasteners

When referring to a file, what does coarseness indicate?
a) Distance between cutting teeth
b) Distance between the tip and the last cutting groove
c) Distance between the base of a groove and the cutting point
d) Distance between tip and handle

Which of the following is not an advantage of hex keys?
a) Any size key will work on any fastener of the same size or smaller
b) Keys give you the choice between extra torque or reach
c) They are inexpensive to produce
d) Only one sized wrench will fit a fastener, reducing the likelihood of damaging the fastener

Which hammer is used to drive a large spike?
a) Sledge
b) Ball-peen
c) Soft-faced
d) Dead blow

Which file shape is sued in difficult or narrow crevices?
a) Triangular
b) Half-round
c) Square
d) Straight

Which file shape is used for slots or keyways?
a) Square
b) Straight
c) Half-round
d) Triangular

Which file shape is used for surfaces and edges?
a) Straight
b) Half-round
c) Square
d) Triangular

Which file shape is used for convaces?
a) Half-round
b) Straight
c) Triangular
d) Square

Which cutting tool is appropriate when cutting power lines?
a) Cable cutter
b) Tin snips
c) Diagonals
d) Wire strippers

Which cutting tool is appropriate when cutting wire insulation?
a) Wire strippers
b) Tin snips
c) Diagonals
d) Cable cutters

Which cutting tool is appropriate when cutting wire?
a) Diagonals
b) Tin snips
c) Cable cutters
d) Wire strippers

Which cutting tool is appropriate when cutting sheet metal?
a) Tin snips
b) Diagonals
c) Cable cutters
d) Wire strippers

What should a vise be secured to?
a) Work bench bolted to the floor
b) Saw horse
c) Mobile work station
d) The wall

Gloves should be worn when removing a workpiece from a machine when the piece could be ______.
a) Hot or sharp
b) Odorous
c) Loose or hot
d)

Which clamp has the strongest holding strength?
a) Vise
b) bar clamp
c) Hand clamp
d)

Play Games with the Questions above at ReviewGameZone.com
To play games using the questions from above, visit ReviewGameZone.com and enter game ID number: 24949 in the upper right hand corner or click here.

TEACHERS / EDUCATORS
Log In
| Sign Up / Register