Tests Review Question Preview (ID: 34689)


This Is A Review For Tests On Printers. TEACHERS: click here for quick copy question ID numbers.

How do you access the 2ndary service menu on a HP m425?
a) Press the setup icon, the space in between the home and the question mark, the return arrow and home icon in a sequence
b) Press setup, the right Arrow button, the Cancel button and setup in a sequence.
c) Press setup, the left Arrow button, the Cancel button and setup in a sequence.
d) Press the setup icon, the space in between the home and the question mark, the return arrow and the setup icon in a sequence

How do you access the 2ndary service menu on a HP m477
a) Press setup, the left Arrow button, the Cancel button and setup in a sequence.
b) Press the setup icon, the space in between the home and the question mark, the return arrow and the setup icon in a sequence
c) Press setup, the right Arrow button, the Cancel button and setup in a sequence.
d) Press the setup icon, the space in between the home and the question mark, the return arrow and home icon in a sequence

How do you perform a HVPS test on a HP M521?
a) Take the cartrigde out, cover the contact that says POM and print an internal report
b) Take the cartrigde out, cover the silver contact that is near the drum. It is the one next to the copper contact.
c) Take the cartrigde out, cover the silver contact that is on the right side of the cartridge and print an internal report
d) Take the cartrigde out, cover the silver contact that is near the drum. It is the one that is alone.

How do you perform a half-self test on a HP m521?
a) Load paper, print an internal report and stop the printing process as soon as the leading edge of the paper is comming out.
b) Load paper, print an internal report and stop the printing process as soon as the leading edge of the paper is goes in
c) Load paper on tray 1, print an internal report and stop the printitng process as soon the whole sheet goes in
d) Load paper on tray 1, print an internal report and stop the printitng process as soon as 3/4 of the paper go in.

How do you perform a HVPS test on a HP m426?
a) Take the cartrigde out, cover the silver contact that is near the drum. It is the one that is alone. Then print,
b) Take the cartrigde out, cover the silver contact that is near the drum. It is the one next to the copper contact and print
c) Take the cartrigde out, cover the slot that is on top of the if with a piece of paper and hold it with some tape and print
d) Take the cartrigde out, cover the contact that says POM and print an internal report

How do you perform a half-self test on a HP m477?
a) Load paper on tray 1, print an internal report and stop the printitng process as soon the whole sheet goes in
b) Load paper on tray 1, print an internal report and stop the printitng process as soon as 3/4 of the paper go in.
c) Load paper, print an internal report and stop the printing process as soon as the leading edge of the paper is goes in
d) Load paper, print an internal report and stop the printing process as soon as the leading edge of the paper is comming out.

How do you Perform an engine test on a HP m426?
a) Printer must be in the Ready state. Open and then fully close the cartridge door in rapid succession 4 times.
b) Find the small hole on the printers right panel and depress the button inside of it .
c) Press the cancel button and the return arrow at the same time. A page with lines should be printed.
d) Remove the printers right side panel. Find the small hole in the lower left of the panel and depress the button inside of it

How do you do a Nvram on a M426 printer?
a) Turn off the printer, hold down the right arrow and the cancel button and turn the printer back on
b) Turn off the printer, hold down the bottom left corner of the screen and turn the printer back on
c) Turn off the printer, hold down the bottom right corner of the screen and turn the printer back on
d) Turn off the printer, hold down the bottom right corner of the screen as soon as you see the HP logo

How do you Perform an engine test on a HP m521?
a) Find the small hole on the printers right panel and depress the button inside of it .
b) Printer must be in the Ready state. Open and then fully close the cartridge door in rapid succession 4 times.
c) Remove the printers right side panel. Find the small hole in the lower left of the panel and depress the button inside of it
d) Press the cancel button and the return arrow at the same time. A page with lines should be printed.

How do you do a Nvram on a M425 printer?
a) Turn off the printer, hold down the bottom right corner of the screen as soon as you see the HP logo
b) Turn off the printer, hold down the bottom right corner of the screen and turn the printer back on
c) Turn off the printer, hold down the bottom left corner of the screen and turn the printer back on
d) Turn off the printer, hold down the right arrow and the cancel button and turn the printer back on

Play Games with the Questions above at ReviewGameZone.com
To play games using the questions from above, visit ReviewGameZone.com and enter game ID number: 34689 in the upper right hand corner or click here.

TEACHERS / EDUCATORS
Log In
| Sign Up / Register